iRobot Floor scrubber Scooba 390 Check Tank Light
What this problem usually means
The Check Tank light normally illuminates when the Clean tank is empty or the Dirty tank is full. It also lights when the tank is missing or not secured, the cleaning cycle is complete, or the pump needs to be primed.
Likely causes
- Clean tank is empty (normal at end of cycle)
- Dirty tank is full
- Tank is not in the robot or is not properly secured
- Cleaning cycle is complete
- Pump needs to be primed
- Battery, filter or vacuum port not properly installed, or solution valve dirty
How to fix it — step by step
- Empty the Dirty and Clean tanks and refill the Clean tank if the cycle is complete
- Place the tank in the robot and make sure the tank latch is securely closed and the tank is completely closed
- Inspect and clean Scooba's solution valve with a damp cloth
- Confirm the battery, filter and vacuum port are properly installed, with the battery tabs inside the guide holes
- Fill the Clean tank with approximately 1 cup of cold water, shake vigorously and empty it to remove debris, then refill with water and cleaning solution or vinegar
- If the pump needs priming, prime Scooba's pump with the included suction bulb fitted over the solution valve, pushing air through 3 or 4 times
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related iRobot Floor scrubber Scooba 390 problems
- I'm Stuck Light - Uh-Oh + 1 Beep
- I'm Stuck Light - Uh-Oh + 2 Beeps
- I'm Stuck Light - Uh-Oh + 3 Beeps
- I'm Stuck Light - Uh-Oh + 4 Beeps
- I'm Stuck Light - Uh-Oh + 5 Beeps
- Power Light (Red)
- Power Light Red Blinking
- Service Light - 4-Tone Alarm + 1 Beep
- Service Light - 4-Tone Alarm + 2 Beeps
- Service Light - 4-Tone Alarm + 3 Beeps
- Service Light - 4-Tone Alarm + 4 Beeps
- Service Light - 4-Tone Alarm + 5 Beeps