iRobot Floor scrubber Scooba 390 I'm Stuck Light - Uh-Oh + 3 Beeps
What it should sound like on your machine
then it repeats
3 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
The I'm Stuck light with an 'uh-oh' followed by 3 beeps means there is a bumper problem.
Likely causes
- Bumper problem
- Debris around the bumper edges
How to fix it — step by step
- Tap the bumper to ensure it moves in and out
- Visually inspect the bumper edges for debris and clear any debris found
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related iRobot Floor scrubber Scooba 390 problems
- I'm Stuck Light - Uh-Oh + 4 Beeps
- I'm Stuck Light - Uh-Oh + 5 Beeps
- Power Light (Red)
- Power Light Red Blinking
- Service Light - 4-Tone Alarm + 1 Beep
- Service Light - 4-Tone Alarm + 2 Beeps
- Service Light - 4-Tone Alarm + 3 Beeps
- Service Light - 4-Tone Alarm + 4 Beeps
- Service Light - 4-Tone Alarm + 5 Beeps
- "Ehh" Sound
- 4-Note Song With Power Button Blinking Red
- Check Brush Light