Hyundai SUV Kona Engine knocking noise and oil use
What this problem usually means
Some first-generation Kona 2.0 Nu MPi engines were built with piston rings that did not meet specification. The rings and cylinder bores can be damaged, and the first signs are a knocking noise from the engine, oil use between services and, in the worst cases, stalling or an oil leak; Hyundai recalled the affected cars, with a dealer inspection and a new engine if damage is found.
Likely causes
- piston rings that did not meet specification → Shop the piston rings at Amazon
- damaged piston rings and cylinder bores
How to fix it — step by step
- Start the engine from cold and listen for knocking or ticking that does not fade
- Check the oil level on the dipstick and note how quickly it drops between services
- Check by VIN whether the piston ring recall inspection or an engine replacement was done
- Stop driving and arrange a tow if the knock gets louder or the engine stalls
- Have a dealer inspect the engine under the recall and replace it if damage is found
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the piston rings.
Parts that commonly fix it
- piston rings - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.