Hyundai SUV Kona Drive unit clicking and grinding noise
What this problem usually means
Some Kona Electric owners report a clicking, tapping or grinding noise from the front drive unit when coasting at low speed or under regenerative braking. Owner theories point to wear in the splines between the motor and the reduction gear, but the cause is not confirmed; owners report dealers replacing reduction gears and in some cases the motor, with mixed results.
Likely causes
- possible wear in the splines between the motor and the reduction gear
How to fix it — step by step
- Coast at low speed with the windows down and listen for clicking or grinding as regenerative braking comes in
- Note whether the noise happens when coasting, under regenerative braking, or both
- Check how much warranty cover is left before authorising any repair
- Have a dealer inspect the drive unit and assess the reduction gear and motor before agreeing to replacement → Shop the reduction gear at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the reduction gear.
Shop the reduction gear at Amazon
Also tied to this fault: electric motor - Shop at Amazon
Parts that commonly fix it
- reduction gear - Shop at Amazon
- electric motor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.