Hyundai Sedan Sonata (YF, 2011–2014) Engine Knocking
What this problem usually means
A metallic, cyclic knock from a 2011-2014 Sonata's Theta II 2.0L/2.4L GDI engine is the recall defect itself: metallic debris left in the crankshaft restricts oil flow to the connecting rod bearings (NHTSA recalls 15V-568 and 17V-226). Hyundai added Knock Sensor Detection System software (Campaign 953) that flashes the check engine light, sets code P1326 and drops the car into limp mode when it detects bearing wear, and extended rod-bearing coverage to 15 years/150,000 miles on covered cars.
Likely causes
- Connecting rod bearing wear from manufacturing debris in the crankshaft
- Oil starvation after heavy Theta II oil consumption
- Spun rod bearing (knock that is loud, deep and constant)
- Piston or valvetrain noise that mimics a rod knock and must be ruled out
How to fix it — step by step
- Stop driving it if the knock is deep and follows RPM, or if the check engine light flashes with a chime; continued driving can seize the engine or start a fire
- Check your VIN at nhtsa.gov/recalls for recalls 15V-568/17V-226 and confirm the KSDS software (Campaign 953) was installed, since coverage can depend on it
- Check the oil level, but do not assume fresh oil fixes a bearing knock
- Have a dealer perform the bearing inspection under the extended warranty (TSB procedure for DTC P1326) before paying an independent shop for an engine
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the connecting rod bearings.
Shop the connecting rod bearings at Amazon
Also tied to this fault: engine short block - Shop at Amazon; knock sensor - Shop at Amazon
Parts that commonly fix it
- connecting rod bearings - Shop at Amazon
- engine short block - Shop at Amazon
- knock sensor - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.