Hyundai Sedan Elantra (HD, 2010–2010) Engine Stalls While Driving

What this problem usually means

RepairPal's top Elantra pattern after the transmission complaint is stalling or failure to start from crankshaft angle sensor failure, with 220 owner reports. The sensor drops the engine's position signal, so the car cuts out — often at speed — and may restart after cooling, which makes it easy to misdiagnose as a fuel problem.

Likely causes

  1. Failed crankshaft angle (position) sensor
  2. Failing fuel pump or pump relay cutting fuel delivery → Shop the fuel pump relay at Amazon
  3. Severe oil starvation on Nu engines that burn oil
  4. Ignition or main relay fault interrupting power intermittently

How to fix it — step by step

  1. Have stored codes read first; a crank sensor fault usually leaves a code even if the car restarted
  2. Note the pattern: stalls when hot and restarts when cool strongly support the crank sensor over the fuel pump → Shop the fuel pump at Amazon
  3. Check the oil level on Nu-engine cars before anything else, since low oil can stall these engines for a very different reason
  4. Replace the crankshaft position sensor if codes and symptoms agree; it is an external sensor, not internal engine work → Shop the crankshaft position sensor at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai Sedan Elantra (HD, 2010–2010) problems

See all Hyundai Elantra (HD, 2010–2010) codes & guides →