Hyundai Sedan Elantra (HD, 2010–2010) Check Engine Light On

What this problem usually means

The Elantra's most characteristic check engine light cause on RepairPal is a failing EVAP canister purge valve, with 122 owner reports: the valve sticks, the car runs roughly after refuelling and sets an EVAP code. It will not strand the car, but it will fail an emissions inspection, and a loose gas cap should always be ruled out first because it sets similar codes.

Likely causes

  1. Failed or sticking EVAP canister purge valve → Shop the canister purge valve at Amazon
  2. Loose, damaged or incorrect gas cap
  3. Cracked EVAP hose or leaking charcoal canister → Shop the charcoal canister at Amazon
  4. Oxygen sensor failure at higher mileage

How to fix it — step by step

  1. Tighten the gas cap until it clicks and drive several trips; a cap code often clears itself → Shop the gas cap at Amazon
  2. Have the exact codes read free at a parts store and write them down before buying parts
  3. For a purge valve code, test whether the valve is stuck open (it should hold vacuum when unpowered) before replacing it
  4. Clear the code after the repair and confirm the light stays off through a full drive cycle

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai Sedan Elantra (HD, 2010–2010) problems

See all Hyundai Elantra (HD, 2010–2010) codes & guides →