Honeywell Air purifier HPA5200 / HPA5250 / HPA5300 / HPA5350 Air Quality Indicator - Red

What this problem usually means

Air Quality Indicator guide (VOC-sensor models only): the VOC Sensor constantly monitors the air and the Air Quality Indicator on the InSight Display illuminates green for good air quality (low VOCs), yellow for moderate air quality, and red for poor air quality (elevated VOCs). On start-up the unit may take a few minutes to calibrate, during which the indicator pulses between green, yellow and red.

Likely causes

  1. Elevated level of VOCs detected in the room - VOCs are gases emitted from certain household cleaning, home improvement and common home decor products
  2. Unit is still calibrating after start-up - the indicator pulses between colours until the reading is determined

How to fix it — step by step

  1. Allow a few minutes after start-up for the sensor to calibrate - the indicator will then remain a solid colour
  2. If the indicator is red, identify and reduce VOC sources in the room where possible
  3. Activate Auto Mode by tapping the Auto button - the purifier will automatically operate at the appropriate cleaning level to reduce the VOCs detected

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Honeywell Air purifier HPA5200 / HPA5250 / HPA5300 / HPA5350 problems

See all Honeywell HPA5200 / HPA5250 / HPA5300 / HPA5350 codes & guides →