Honda SUV Passport Engine ticking noise
What this problem usually means
Owners of the 1996 Passport noticed that varnish buildup in the engine can cause the hydraulic lash adjusters to stick. The sticking adjusters produce a ticking noise from the engine, and the noise may stop once the hydraulic lifter is located and cleaned.
Likely causes
- varnish buildup in the engine
- sticking hydraulic lash adjusters
How to fix it — step by step
- Note whether the ticking is present on a cold start, at idle, or at all engine speeds
- Check the oil level and condition, since varnish builds up in neglected oil
- Have a shop confirm the noise is coming from the lash adjusters rather than another engine part
- Clean or replace the sticking hydraulic lash adjusters and change the oil → Shop the hydraulic lash adjusters at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hydraulic lash adjusters.
Parts that commonly fix it
- hydraulic lash adjusters - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Honda manual is on Honda's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.