Ford Coupe Mustang Rear brakes dragging
What this problem usually means
On some Mk5 Mustangs the rear sealing boot on the parking brake cable can perish, letting in water that freezes in cold weather. The seized cable then causes the rear brakes to drag, wearing them out early, slowing the car, and raising fuel use.
Likely causes
- perished rear sealing boot on the parking brake cable
- water freezing inside the parking brake cable
- seized parking brake cable
How to fix it — step by step
- Stop and let hot, dragging brakes cool if you smell burning or feel the car being held back
- Check whether a rear wheel is unusually hot after a short drive in cold weather
- Inspect the parking brake cable boots for perishing or splits that let water in
- Replace both parking brake cables if one is seized, rather than only the failed side → Shop the parking brake cables at Amazon
- Test that the rear brakes release fully with the parking brake off
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the parking brake cables.
Parts that commonly fix it
- parking brake cables - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Ford manual is on Ford's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.