Ford Coupe Mustang Long crank time and check engine light
What this problem usually means
For 17 model years of Mustang, RepairPal reports the magnet for the camshaft position sensor can fall out of its mount and damage the nearby synchronizers. Owners experienced long crank times and an illuminated check engine light, typically around 110,000 miles.
Likely causes
- camshaft position sensor magnet falling out of its mount
- damage to the synchronizers
How to fix it — step by step
- Scan for stored fault codes when the check engine light comes on
- Note whether long crank times happen on every start or only when warm
- Have a shop inspect the camshaft sensor magnet and its mount → Shop the camshaft sensor magnet at Amazon
- Replace the magnet and repair any synchronizer damage found
- Clear the codes and confirm the engine starts promptly with no warning light
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the camshaft sensor magnet.
Parts that commonly fix it
- camshaft sensor magnet - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Ford manual is on Ford's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.