Eufy Robot vacuum RoboVac G30 Error S4

What this problem usually means

Voice prompt 'Error S4: Suction Fan Error' — a suction fan fault.

Likely causes

  1. Fan blades stuck in an unknown object
  2. Dust collector or filter clogged
  3. Suction fan fault

How to fix it — step by step

  1. Power off the RoboVac
  2. Remove the dust collector and filter; verify the filter was installed correctly, and clean both the dust collector and filter → Shop the filter at Amazon
  3. Inspect the suction inlet and suction fan blades for debris stuck in them; hold the RoboVac with the suction inlet facing down and shake it repeatedly to dislodge anything inside
  4. Reinstall the filter in the dust collector and insert the dust collector securely
  5. Power on, place the RoboVac back on the charging base and start a clean to verify the suction fan error is cleared; if it persists, contact Eufy support

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Eufy Robot vacuum RoboVac G30 problems

See all Eufy RoboVac G30 codes & guides →