Electrolux Washer E62 Error Code
What the E62 code means
Overheating during washing: the water temperature rose too high (above about 88 degrees C) during the wash.
Likely causes
- Failed NTC temperature sensor
- Heating element fault or stuck heater relay
- Hot and cold hoses reversed
- Control board fault
How to fix it — step by step
- Stop the cycle and unplug the washer
- Check the fill hoses are on the correct taps (cold to cold)
- Do not run hot cycles until it is checked
- Book service to test the temperature sensor and heater circuit
Parts that commonly fix the E62 code
- temperature sensor - Shop at RepairClinic
- heating element - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.