Dyson Air purifier Pure Cool Link TP02 E (flashing)
What this problem usually means
A flashing 'E' on the LED display means the machine is unable to do what has been requested.
Likely causes
- Room temperature at or below 5C
- Blockage in the inlet grille or loop amplifier outlet
- Filter blocked by excessive dust build-up or due for replacement
- Plug not firmly connected, or machine not switched on at the wall
How to fix it — step by step
- Make sure the room temperature is above 5C (41F).
- Check there are no blockages in the inlet grille or the loop amplifier outlet.
- Check the filter is correctly assembled and does not need replacing.
- Make sure the machine is correctly plugged directly into a wall outlet.
- If the message still displays, unplug the machine and leave it for 10 seconds before turning it on again.
- If the problem persists, call the Dyson Helpline.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.