Dreame Robot vacuum Dreame L20 Ultra The water level in the washboard is abnormal

What this problem usually means

The base station washboard (mop-washing tray) holds an abnormal water level during mop washing.

Likely causes

  1. The seal on the used water tank is loose or not correctly installed
  2. The used water tank is not installed correctly
  3. The sewage drain under the washboard is blocked
  4. A liquid other than the officially-approved cleaning solution was added

How to fix it — step by step

  1. Check whether the seal on the used water tank is loose or not correctly installed, and manually reset it if so
  2. Gently press down on the used water tank to make sure it is installed correctly
  3. Remove the washboard and check whether the sewage drain is blocked, and clean it
  4. Check the cleaning solution; do not add any liquid other than the officially-approved cleaning solution
  5. If the problem persists, contact the after-sales service team

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Dreame Robot vacuum Dreame L20 Ultra problems

See all Dreame Dreame L20 Ultra codes & guides →