Dreame Robot vacuum Dreame L20 Ultra The robot cannot find and return to the base station

What this problem usually means

After cleaning, the robot cannot locate or dock with its base station on its own.

Likely causes

  1. Base station was disconnected from power or moved while the robot was not on it
  2. Too many obstructions around the base station
  3. The robot was moved during cleaning and re-positioning failed
  4. Dust or debris on the base station signaling area

How to fix it — step by step

  1. Connect the base station to the power supply, or place the robot onto the base station to charge
  2. Place the base station in a more open area with fewer obstructions around it
  3. If the robot is too far from the base station to return on its own, manually place the robot onto the base station
  4. Wipe the signaling area on the base station to remove dust or debris

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Dreame Robot vacuum Dreame L20 Ultra problems

See all Dreame Dreame L20 Ultra codes & guides →