Coway Air purifier Airmega 250 Filter reset indicator (orange)
What this problem usually means
The Airmega 250 filter reset indicator stays on during the filter cleaning/replacement cycle, and when the cleaning cycle or filter life becomes less than 2%, the corresponding indicator emits an orange light. Separate PRE and MAX2 indicators cover the pre-filter and the Max2 filter.
Likely causes
- Pre-filter cleaning cycle or Max2 filter life is running out (less than 2% remaining)
- Filter cleaning or replacement cycle is in progress
How to fix it — step by step
- Clean the pre-filter or replace the Max2 filter as the corresponding indicator requires - the Max2 filter life is approximately 12 months based on daily 8-hour use at maximum speed → Shop the max2 filter (activated carbon + green true hepa) at Amazon → Shop the pre-filter at Amazon
- Turn the product on and press the corresponding filter reset button for more than 3 seconds after cleaning and replacing the filter
- If both the PRE and MAX2 indicators are on at the same time, the filters can be reset at once
- Note: if the filter replacement indicator is not turned on, the related reset button functions do not operate
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the pre-filter.
Also tied to this fault: Max2 filter (activated carbon + Green True HEPA) - Shop at Amazon
Parts that commonly fix it
- pre-filter - Shop at Amazon
- Max2 filter (activated carbon + Green True HEPA) - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.