Buick SUV Envision (Second generation, 2021–2025) Crankshaft end play (thrust bearing wear)

What this problem usually means

A rare but serious fault on the second-generation Envision's 2.0L (LSY): the crankshaft thrust bearing wears, letting the crankshaft move axially beyond tolerance. The what-breaks guide cites GM bulletin PIP6047 - dealers may only measure endplay, and if it exceeds tolerance GM approves a full engine exchange, with no in-car repair.

Likely causes

  1. Worn crankshaft thrust bearing
  2. Excessive crankshaft end play

How to fix it — step by step

  1. Listen for scraping noise near the harmonic balancer and watch for unexplained timing codes or front transmission seal leaks
  2. Have a dealer measure crankshaft endplay per bulletin PIP6047
  3. Do not plan a partial repair - GM's documented remedy for out-of-tolerance endplay is engine replacement
  4. If in tolerance, keep documented measurements and monitor at each service

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Buick SUV Envision (Second generation, 2021–2025) problems

See all Buick Envision (Second generation, 2021–2025) codes & guides →