Buick SUV Envision (Second generation, 2021–2025) Coolant flow valve failure
What this problem usually means
The second-generation Envision's 2.0L (LSY) replaces the thermostat with an electronically controlled coolant flow valve, and that valve is a known weak point. The what-breaks guide says a sticking valve or disagreeing sensors set codes P00B7, P0128 or P2681 - sometimes under 50,000 miles - with loud fans, weak cabin heat and a swinging temperature gauge; GM bulletin PIP5578 covers the condition.
Likely causes
- Sticking coolant flow control valve
- Coolant temperature sensor disagreement
How to fix it — step by step
- Have codes read - P00B7, P0128 or P2681 point at the thermal management system
- Watch the temperature gauge and cabin heat for the swinging/weak pattern
- Do not ignore it - left alone it risks overheating
- Replace the coolant flow control valve following GM's bulletin procedure → Shop the coolant flow control valve at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the coolant flow control valve.
Parts that commonly fix it
- coolant flow control valve - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.
Related Buick SUV Envision (Second generation, 2021–2025) problems
See all Buick Envision (Second generation, 2021–2025) codes & guides →