BMW Sedan 5 Series Engine stalls when stopping
What this problem usually means
The torque converter clutch can stick 'on' after extended freeway driving, causing the engine to stall when coming to a stop. It restarts in Park, stalls again in gear, and works normally after about twenty minutes of cooling. Repair requires replacement of the torque converter clutch solenoid, transmission filter and fluid.
Likely causes
- Torque converter clutch sticking after extended freeway driving
- Torque converter clutch solenoid fault → Shop the torque converter clutch solenoid at Amazon
How to fix it — step by step
- Confirm the stall pattern follows freeway driving and clears after cooling
- Scan transmission fault codes
- Replace the TCC solenoid, filter and fluid
- Road-test to confirm
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the torque converter clutch solenoid.
Shop the torque converter clutch solenoid at Amazon
Also tied to this fault: transmission filter - Shop at Amazon; automatic transmission fluid - Shop at Amazon
Parts that commonly fix it
- torque converter clutch solenoid - Shop at Amazon
- transmission filter - Shop at Amazon
- automatic transmission fluid - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.