BMW Sedan 5 Series Clunking noise when braking
What this problem usually means
A clunk noise or jolt felt in the steering when braking is caused by wear of the front control arm bracket bushings (thrust rod bushings). The repair is bushing replacement and a wheel alignment check. (The 5 Series' already-covered bushing entry concerns the rear control arms; this is the front bracket/thrust rod set.)
Likely causes
- Worn front control arm bracket (thrust rod) bushings → Shop the front control arm bushing at Amazon
How to fix it — step by step
- Reproduce the clunk under braking
- Inspect front bracket bushings for cracking/play
- Replace the bushings
- Check and adjust wheel alignment
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the front control arm bushing.
Parts that commonly fix it
- front control arm bushing - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.