Acura SUV RDX (TC1/TC2, 2019–2020) Engine Stalls — Fuel Pump Recalls

What this problem usually means

The third-generation RDX (2019–2020 especially) was recalled three times for the same in-tank low-pressure fuel pump: 20V314 (2019 models), expanded by 21V215 (2019–2020), and expanded again by 23V858 (December 2023). In each, the pump impeller can deform and fail, stalling the engine at speed or preventing a start. The NHTSA recall texts name the RDX explicitly in all three campaigns.

Likely causes

  1. Fuel pump impeller swelling and deformation
  2. Impeller failure accelerated by heat
  3. Pump motor stall from impeller contact

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls — a 2019–2020 RDX may appear in more than one wave
  2. Have the dealer replace the fuel pump module free under the applicable campaign → Shop the fuel pump module at Amazon
  3. Keep fuel above a quarter tank until the replacement is done
  4. If a stall happens after a previous recall repair, report it — repeat stalls on this component are documented

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Acura SUV RDX (TC1/TC2, 2019–2020) problems

See all Acura RDX (TC1/TC2, 2019–2020) codes & guides →