Acura Sedan TLX (UB5/UB6/UB7, 2021–2025) Engine Stalls After Stopping — Fuel Injector ECU Recall
What this problem usually means
Safety recall 25V031 covers 2021–2025 TLX Type S (and 2022–2025 MDX Type S): a software error in the fuel injection electronic control unit (FI-ECU) can cause the engine to stall when the vehicle comes to a stop or idles — 294,612 vehicles recalled across the whole campaign, which also includes the 2023–2025 Honda Pilot. The fix is a dealer software update, not parts.
Likely causes
- FI-ECU software calibration error
- Incorrect idle fuel control after deceleration
- Software fault triggered at stop or idle
How to fix it — step by step
- Check your VIN at nhtsa.gov/recalls for campaign 25V031
- Book the free dealer FI-ECU software update
- Until updated, note that stalls occur at stops — restart in neutral and allow extra following distance
- Confirm the update version on the repair order before leaving
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.