Winix Air purifier 5500-2 PlasmaWave Chirping or Buzzing Sound
What this problem usually means
A chirping or buzzing sound while the unit is running is normal on this model: the manual states the sound comes from particles passing through PlasmaWave and does not signify product failure.
Likely causes
- Large particles passing through PlasmaWave while the unit is running
- PlasmaWave is enabled - it is enabled by default when the unit is first powered on
How to fix it — step by step
- No repair is needed if the sound is the PlasmaWave chirping or buzzing described in the manual
- If you want to confirm the source, press the PlasmaWave button while the unit is on to disable PlasmaWave and listen for the sound to stop
- Press the PlasmaWave button again to re-enable the feature if desired
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.