Whirlpool Washer Cabrio (Top-Load) Ld Error Code
What the Ld code means
Long drain on Cabrio models: the water level does not change after the drain pump turns on.
Likely causes
- Drain hose kinked or clogged
- Drain hose installed incorrectly or too high
- Clogged or failed drain pump
How to fix it — step by step
- Check the drain hose is not kinked or clogged
- Check the drain hose is installed properly
- Press Pause/Cancel to clear the display and restart
- Clean the pump filter if accessible → Shop the drain pump at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the Ld code
- drain pump - Shop at RepairClinic or Amazon
Before you buy: check the drain pump first
Test: Unplug the washer, disconnect the wire connector at the pump, set the meter to the R×1 scale, and measure across the pump terminals.
A good one reads: Approximately 12.3 Ω (Whirlpool CHW9050 service manual). The value is generation-specific: Duet-era tech sheets spec 15 Ω and current Whirlpool tech sheet W11417646 specs 18.5–21.5 Ω, so confirm against your model's tech sheet.
Test values from manualslib.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.