Whirlpool Dishwasher F9 E1 Error Code

What the F9 E1 code means

Platform-dependent: on current Whirlpool models this is a long drain - the dishwasher is not draining. On older HE models the same code means the control cannot determine the position of the diverter disc that directs water to the spray arms.

Likely causes

  1. Clogged filter or kinked / clogged drain hose (current platform)
  2. Garbage disposer knockout plug not removed on a new install, or a blocked air gap
  3. Defective diverter motor or a leaking diverter seal (older platform), or a failed drain pump

How to fix it — step by step

  1. Remove the filter and clean it thoroughly under running water
  2. Check the drain hose for kinks, pinches or clogs from the dishwasher to the sink
  3. If connected to a disposer, make sure it is clear and the knockout plug was removed; clear the air gap if fitted
  4. Cut power for 30 seconds, restore it, and run a cancel / drain; if the code returns, schedule service

Parts that commonly fix the F9 E1 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Whirlpool dishwasher error codes

See all Whirlpool dishwasher codes & guides →