Whirlpool Dishwasher F6 E1 Error Code
What the F6 E1 code means
Platform-dependent: on older HE models this means the dishwasher will not fill / no water is detected; on Whirlpool's current support pages F6 E1 is listed as a user interface error, main control, and the dishwasher will not start or resume a cycle.
Likely causes
- Water supply turned off, stuck overfill float, or clogged inlet valve screen (fill platform)
- User interface / main control communication fault (current platform)
- Low household water pressure (below about 20 psi)
How to fix it — step by step
- Make sure the water supply valve to the dishwasher is fully open and the supply hose is not kinked
- Lift and lower the overfill float in the front corner of the tub to check it moves freely and clicks
- Power-cycle the dishwasher: unplug or breaker off for 30 seconds to 1 minute, then restore power
- If the code returns, schedule service
Parts that commonly fix the F6 E1 code
- water inlet valve - Shop at RepairClinic
- user interface control - Shop at RepairClinic
- main control board - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.