Toyota SUV RAV4 (XA50, 2019–2021) Hybrid warning light on

What this problem usually means

On 2019-2021 RAV4 Hybrids, the high-voltage cable connector at the rear motor can corrode (an issue owners call Cablegate), triggering hybrid system warnings and, in the worst case, disabling the hybrid system. It is a documented fifth-generation hybrid problem, and the corroded connector is a high-voltage component, so inspection and repair belong to a qualified shop.

Likely causes

  1. Corrosion of the high-voltage rear motor cable connector, worsened by road salt → Shop the high-voltage cable and connector at Amazon
  2. Damaged cable shielding or connector seal letting moisture in
  3. 12V battery failure causing unrelated hybrid warnings (rule out first)
  4. Inverter or hybrid control faults (less common)

How to fix it — step by step

  1. Have the 12V battery tested first; a weak 12V battery causes many spurious hybrid warnings and is cheap to rule out → Shop the 12v battery at Amazon
  2. Have stored hybrid codes read by a shop equipped for Toyota hybrids
  3. Ask a Toyota dealer whether any special coverage or service campaign applies to the cable for your VIN and region
  4. Do not open or probe the orange high-voltage cabling yourself; connector replacement is shop work

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Toyota SUV RAV4 (XA50, 2019–2021) problems

See all Toyota RAV4 (XA50, 2019–2021) codes & guides →