Toyota Sedan Corolla Water pump failure and coolant leak
What this problem usually means
Corollas from around 2009-2010 are commonly reported with water pump failure and coolant leakage, typically at 60,000-80,000 miles. A failing pump can weep coolant from its bearing/seal area and, if ignored, lead to overheating.
Likely causes
- Worn water pump bearing and seal
- Age and mileage wear on the pump
- Coolant loss lowering the cooling system level
How to fix it — step by step
- Check the coolant level in the reservoir when the engine is cold
- Look for pink coolant crust or drips near the water pump and drive belt area → Shop the water pump at Amazon
- Watch the temperature gauge and stop if it climbs above normal
- Replace the water pump (and inspect the drive belt) and refill/bleed the cooling system
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water pump.
Also tied to this fault: water pump gasket - Shop at Amazon
Parts that commonly fix it
- water pump - Shop at Amazon
- water pump gasket - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.