Toyota Sedan Camry (XV70, 2018–2020) Engine stalls while driving

What this problem usually means

Many 2018-2020 Camrys were recalled (NHTSA recalls 20V012 and 20V682) because the in-tank Denso low-pressure fuel pump can fail, causing rough running, a no-start, or stalling while driving. Because it is a recall, the fix is free at a Toyota dealer for covered cars.

Likely causes

  1. Failing Denso low-pressure fuel pump covered by recall
  2. Clogged fuel filter or failing pump relay on older cars → Shop the fuel pump relay at Amazon
  3. Failing crankshaft position sensor cutting the engine intermittently → Shop the crankshaft position sensor at Amazon
  4. Severe vacuum leak or throttle body fault (usually sets codes first)

How to fix it — step by step

  1. Check your VIN at nhtsa.gov/recalls first; if the fuel pump recall is open on your car, book the free dealer repair before paying for diagnosis → Shop the fuel pump at Amazon
  2. Note whether the stall happens hot, cold, or at random, and whether the car restarts immediately, which helps separate pump from sensor faults
  3. Have stored codes read; a crank sensor fault usually leaves evidence
  4. If the recall does not apply, have fuel pressure tested before replacing the pump on suspicion

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Toyota manual is on Toyota's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Toyota Sedan Camry (XV70, 2018–2020) problems

See all Toyota Camry (XV70, 2018–2020) codes & guides →