Tesla SUV Model X (All models) Falcon wing doors detect phantom obstacles

What this problem usually means

The Falcon Wing doors navigate by ultrasonic sensors in the doors and roof, and those sensors drift out of calibration, get dirty, or misread heat and direct sunlight as an obstacle. The result is doors that stop halfway, refuse to open or close in a clear space, or open to different heights on each side. It is worst on 2016-2019 cars and can recur over the car's life.

Likely causes

  1. Ultrasonic sensors drifted out of calibration
  2. Dirty or failed ultrasonic sensor
  3. Heat or direct sunlight fooling the sensors into seeing an obstacle
  4. Door misalignment confusing the sensor picture

How to fix it — step by step

  1. Cycle both doors fully in a clear, shaded space and note which door misbehaves and where in its travel it stops
  2. Clean the sensor areas on the doors and roof and retest; grime alone can cause false readings
  3. Note whether it happens mainly in heat or direct sun, which supports a sensor misread over a mechanical fault
  4. Persistent faults need sensor recalibration and a door alignment check at Tesla or a specialist; a failed sensor or actuator is replaced individually

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Tesla manual is on Tesla's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Tesla SUV Model X (All models) problems

See all Tesla Model X (All models) codes & guides →