Tesla Sedan Model 3 (All models) Frunk won't open

What this problem usually means

With a dead low-voltage battery, a Model 3 cannot open the frunk with the app, key or screen, which is a trap because the 12V battery you need to reach lives under the frunk. Tesla provides external jump terminals behind the front tow-eye cover specifically for this situation.

Likely causes

  1. Dead 12V battery (by far the most common cause)
  2. Failed frunk latch actuator (suspect this only if the 12V system is alive)
  3. Frozen or misaligned frunk latch in winter

How to fix it — step by step

  1. Pop the round tow-eye cover on the front bumper and pull out the two frunk release leads
  2. Touch a 12V jump pack or jumper cables to those leads to pop the frunk; this only releases the latch, it does not jump the car
  3. Access the 12V battery under the frunk's rear panel and jump or replace it
  4. If the frunk still will not release with power applied, the latch actuator itself needs service → Shop the frunk latch actuator at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Tesla manual is on Tesla's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Tesla Sedan Model 3 (All models) problems

See all Tesla Model 3 (All models) codes & guides →