Subaru SUV Outback (BR, 2010–2014) Engine stalls when stopping

What this problem usually means

Early CVT Outbacks (around 2010) have documented complaints of the torque converter locking up when braking, which can drag the engine down and stall it as the car comes to a stop, exactly as a manual-transmission car stalls if the clutch is not pressed. It is a converter control problem, not an engine fault.

Likely causes

  1. Torque converter lock-up clutch not releasing when braking → Shop the torque converter at Amazon
  2. CVT valve body fault controlling converter lock-up
  3. Dirty throttle body causing low-speed stalls (a cheaper sound-alike to rule out)
  4. Failing crank sensor (usually stalls at other times too)

How to fix it — step by step

  1. Note whether stalls happen only while braking to a stop, the converter lock-up pattern, or randomly, which points elsewhere
  2. Clean the throttle body and check for codes first; it is the cheap overlap cause
  3. Ask a dealer whether any CVT warranty extension or TSB covers your car for converter behavior
  4. A confirmed converter/valve body fault is transmission work for a specialist → Shop the valve body at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Subaru SUV Outback (BR, 2010–2014) problems

See all Subaru Outback (BR, 2010–2014) codes & guides →