Sony TV GN1T chassis / certain Android TV models (Sony 8-blink software procedure) 8 Blinks
What it should look like on your machine
then it repeats
8 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
The red standby LED blinks eight times, pauses, and repeats. On GN1T-chassis models (XBR-X830C, 2015) Sony's service manual lists 8 blinks as a Software Error (SW_ERR), and Sony's official support article for certain models ties this pattern to a software/network issue where the TV turns off and on by itself or reboots, prescribing disconnecting the network, a power reset, a factory reset, and a system software update. On EX2L-chassis models the same count is an Audio error instead — see the separate EX2L 8-blink entry. Blink meanings vary by model and generation, so always confirm against your exact model's service documentation.
Likely causes
- Corrupted software or failed network-related process on affected Android models
- Main board audio protection / system protection fault on KDL-era models
- Failed main board integrated circuit
- Outdated or corrupted firmware
How to fix it — step by step
- Disconnect all devices from the TV, including any modem, router, or LAN cable connection, and turn off the router/modem if using Wi-Fi
- Perform a power reset: unplug the TV power cord, leave it without power for 60 seconds, then plug it directly into a wall outlet and turn it on
- Perform a factory reset — on older models hold the UP ARROW on the remote while pressing and releasing POWER on the TV, then complete initial setup skipping network and IR blaster setup
- Reconnect the TV to the internet manually and perform a system software (firmware) update, or download the update for your exact model from Sony's support site to a FAT32 USB drive and update via USB
- Perform a factory reset again after the update; if the 8-blink pattern persists, the main board requires replacement → Shop the main board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main board.
Parts that commonly fix it
- main board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.