Sony TV AZ1-K chassis (KDL-32FA600) 3 Blinks

What it should look like on your machine

then it repeats

3 blinks - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

The red standby LED blinks three times, pauses, and repeats. On AZ1-K-chassis models (KDL-32FA600) Sony's service manual self-diagnosis table lists 3 blinks as an Audio Error on the A (main) board — not the DC-alert meaning the same count carries on AZ1-L/AZ2/GN1T chassis, and EX2L-chassis models do not use 3 blinks for this fault at all (their DC alert is 5 blinks). Always confirm against your exact model's service documentation.

Likely causes

  1. Audio amplifier / audio protection fault on the main (A) board
  2. Failed main board
  3. Shorted speaker or speaker wiring triggering audio protection

How to fix it — step by step

  1. Disconnect all external devices including HDMI cables and speakers, then perform a power reset: unplug the TV for 2 minutes and plug it back in
  2. Inspect speaker connections on the main board and reseat them if loose → Shop the main board at RepairClinic
  3. If the 3-blink pattern returns, the main (A) board requires service or replacement matched to your exact model number

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Sony TV AZ1-K chassis (KDL-32FA600) problems

See all Sony AZ1-K chassis (KDL-32FA600) codes & guides →