Shark Air purifier HP300 Series Check Dust Filters
What this problem usually means
The front display shows a pulsing red ring along with the text 'check dust filters' when the mesh dust filters need maintenance. The filter icon also flashes when Dust Filter Life reaches 0%.
Likely causes
- Mesh dust filter screens loaded with dust and debris
- Dust Filter Life counter has counted down to 0%
How to fix it — step by step
- Leave the purifier plugged in and running while you service the dust filters.
- Gently slide both mesh dust filters up to remove them from the unit. → Shop the mesh dust filters at Amazon
- Inspect the filter screens for dust and debris build-up.
- Vacuum the screens on low speed with a soft brush attachment, or wipe them with a cloth or towel. Do not use abrasive chemical cleaners.
- For extra cleaning, rinse the screens with room-temperature tap water and let them dry completely for 12 hours before reinstalling. Never use the purifier with wet filters.
- Reinsert the filters so they sit flush with the body of the unit. The unit recalibrates (rotating lights) and resumes analysing air quality.
- To reset the reminder manually, press and hold the filter icon on the top control panel for 1.5 seconds.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Mesh dust filters.
Parts that commonly fix it
- Mesh dust filters - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.