Shark Air purifier HE600 Series Filter Life button flashing
What this problem usually means
The Filter Life display counts down the filter's remaining life in hours. When it reaches 0 hours remaining, the Filter Life button flashes - it is time to install a new filter.
Likely causes
- Filter life timer has reached 0 hours remaining
- True HEPA Multi-Filter is at the end of its service life → Shop the shark air purifier multi-filter (true hepa) at Amazon
How to fix it — step by step
- Turn the purifier off and unplug it.
- Press the tabs at the top of the back cover and pull the cover towards you to remove it.
- Pull the old filter out by the tabs at the top and bottom and discard it.
- Remove all packaging from the new filter.
- Insert the new filter, then replace the cover: fit the bottom tabs into the slots and press the top, then the sides, until it clicks into place.
- Plug the unit in and turn it on. Calibration begins automatically.
- Press and hold the Filter Life button for 3 seconds to reset the timer. The unit beeps when the timer is activated.
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Shark Air Purifier Multi-Filter (True HEPA).
Shop the Shark Air Purifier Multi-Filter (True HEPA) at Amazon
Parts that commonly fix it
- Shark Air Purifier Multi-Filter (True HEPA) - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.