Samsung Dishwasher Rotary spray-arm models 1E Error Code
What the 1E code means
High temperature heater error on rotary spray-arm models: the temperature inside the dishwasher is too hot. Samsung lists the same fault as HC on these models.
Likely causes
- Clogged fine filter on WaterWall models
- Overheating inside the tub on rotary models
- Heater or temperature sensing fault on rotary models
How to fix it — step by step
- Remove and clean the fine filter at the bottom of the dishwasher per the manual
- On rotary models, switch power off at the breaker for 30 seconds, empty the dishwasher, add detergent and run a Normal cycle
- If the code returns after cleaning or the test cycle, request service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the 1E code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.