Roborock Robot vacuum S4, S4 Max, S5 Max, S6 Pure, S6 MaxV Error 24
What this problem usually means
Virtual no-go zone or wall detected. Numbered as Error 24 only in S-series manuals of the S4/S5/S6 generation (verified in the S4, S4 Max, S5 Max, S6 Pure and S6 MaxV manuals). The robot started in, or ran into, a no-go zone, Invisible Wall or barrier tape area. The Q-series and S7-series manuals list the same condition without a number, and the E-series manuals do not list it.
Likely causes
- Robot placed inside an app no-go zone or Invisible Wall area
- Robot too close to magnetic barrier tape
- Map no-go zone covering the starting position
How to fix it — step by step
- Move the robot out of the no-go zone and away from any barrier tape
- Place it in an open, allowed area
- Check the map in the app if a no-go zone is covering where you want it to clean
- Restart cleaning
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Roborock Robot vacuum S4, S4 Max, S5 Max, S6 Pure, S6 MaxV problems
See all Roborock S4, S4 Max, S5 Max, S6 Pure, S6 MaxV codes & guides →