Roborock Robot vacuum S4 Max, S6, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV Error 21

What this problem usually means

Vertical bumper pressed. The vertical bumper / laser rangefinder bumper at the front of the LiDAR area is pressed in and cannot release (the S6 manual words the same code as 'height sensor has been pressed'). Verified in the S4 Max, S6, S6 MaxV, Q5/Q7 Max and S7/S7 MaxV manuals. The S5 Max and S6 Pure manuals do not list Error 21, and the E3 manual states it is not applicable to the E series.

Likely causes

  1. Robot wedged against a wall or furniture pressing the vertical bumper
  2. Debris holding the vertical bumper in
  3. Object resting against the front sensor housing

How to fix it — step by step

  1. Move the robot away from the wall or object pressing on it
  2. Check the vertical bumper and clear any debris around it
  3. Press and release it to check it moves freely
  4. Move the robot to an open area and retry

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Roborock Robot vacuum S4 Max, S6, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV problems

See all Roborock S4 Max, S6, S6 MaxV, Q5, Q7 Max, S7, S7 MaxV codes & guides →