Roborock Robot vacuum S4 Max, S5 Max, S6, S6 Pure Error 22
What this problem usually means
Recharge sensor blocked by dust - 'wipe the recharge sensor' (S-series manuals of the S4 Max / S5 Max / S6 generation, verified in the S4 Max, S5 Max, S6 and S6 Pure manuals). Dust on the robot's recharge sensor stops it reading the dock. Do not confuse this with Error 22 on S6 MaxV, Q-series and S7-series models, where the same number means a dock locator error (see the other Error 22 entry).
Likely causes
- Recharge sensor window dirty or covered in dust
How to fix it — step by step
- Find the recharge sensor on the robot and wipe the dust off it with a dry cloth
- Make sure nothing blocks the dock's signal area
- Place the robot in front of the dock and retry docking
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Roborock Robot vacuum S4 Max, S5 Max, S6, S6 Pure problems
See all Roborock S4 Max, S5 Max, S6, S6 Pure codes & guides →