Roborock Robot vacuum E Series Error 20
What this problem usually means
Motion tracking sensor dirty or blocked (E3 manual: 'Please clean the motion tracking sensor and place the machine back to its original location and start it'). The E series navigates using the motion tracking sensor underneath the robot instead of a LiDAR turret, and this code appears only in the E-series fault table - the same E3 manual notes that Errors 1, 15, 16, 19, 21 and 22 belong to other models, while Error 20 is the E series' own sensor code.
Likely causes
- Dust or dirt covering the motion tracking sensor window
- Sensor blocked by debris or a stuck omni wheel area build-up
How to fix it — step by step
- Turn the robot over and find the motion tracking sensor on the underside
- Wipe the sensor clean with a dry cloth
- Place the robot back near its original location on level floor
- Restart cleaning
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Roborock manual is on Roborock's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.