Rheem Furnace 10 Error Code

What the 10 code means

One-hour lockout on Rheem furnaces with the 7-segment diagnostic display. The control locked out after repeated ignition or flame failures and will retry after the lockout period.

Likely causes

  1. repeated failed ignition (shown with code 11)
  2. repeated flame loss (shown with code 13)
  3. unexpected flame lockout (shown with code 14)

How to fix it — step by step

  1. Check the thermostat is set to Heat and the furnace power switch and breaker are on
  2. Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
  3. Turn power off for 30 seconds, then back on, and allow one retry cycle
  4. Do not keep resetting a furnace that repeatedly fails to light
  5. If it locks out again, call a licensed HVAC technician and note the code

Parts that commonly fix the 10 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Rheem furnace error codes

See all Rheem furnace codes & guides →