RAM Truck 1500 Transmission shifting hard and clunking
What this problem usually means
Ram 1500s with the ZF-sourced 8-speed automatic commonly draw complaints of hard shifts, especially between 1st and 2nd gear, and gear hunting during highway towing. Many owners also report a distinct clunk when coming to a stop or accelerating from a standstill, which can often be traced to the driveshaft slip yoke needing lubrication or a software update for the transmission control module.
Likely causes
- Transmission control module software needing an update
- Dry driveshaft slip yoke causing a stop-and-start clunk
- Degraded transmission fluid from heat, especially with heavy towing
How to fix it — step by step
- Note which shifts are hard and whether the clunk happens at stops or on take-off
- Ask a dealer about transmission control module software updates for the truck
- Have the driveshaft slip yoke inspected and lubricated
- Have the transmission fluid exchanged, proactively around every 60,000 miles for towing use, rather than treating the unit as sealed for life
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the automatic transmission fluid.
Parts that commonly fix it
- automatic transmission fluid - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.