Washer won't drain
A washer that finishes the cycle sitting in water almost always has a blockage or a hose problem rather than a dead machine. These checks go from the drain hose outside the machine to the pump inside it.
First checks — these apply to every brand
- Run a Drain & Spin cycle — If the cycle was paused, cancelled or is still spinning down, the water may simply not have drained yet. Close the lid or door and run a Drain & Spin (or Spin-only) cycle and watch whether the water leaves.
- Inspect the drain hose for kinks and clogs — Pull the washer out a little and check the drain hose along its whole length: kinks, crushing where the washer has been pushed back against the wall, and lint clogs are the top causes. In cold spaces, a frozen hose will also block draining.
- Check how the hose sits in the standpipe — A hose pushed too far into the standpipe, sealed in airtight, or at the wrong height can siphon water back or drain painfully slowly. It should sit loosely in the drain at the height your manual specifies, with an air gap.
- Rule out excess suds — Too much detergent, or non-HE detergent in a high-efficiency washer, creates suds that fool the water-level sensor and slow or stall draining. If the tub is full of foam, let it settle, run a rinse and spin, and use less detergent next load.
- Clean the drain pump filter (most front-loaders) — Unplug the washer, put a shallow pan and towels at the lower front panel, drain the residual water through the small hose, then unscrew the pump filter. Coins, lint, hairpins and sock fragments trapped here are the single most common fix.
- Check for an object jammed in the pump — If the washer hums or grinds when it should be draining, something is likely lodged in the pump impeller. After cleaning the filter, look and feel inside the pump housing for coins or debris and remove anything you find.
- Make sure the house drain is clear — If water backs up out of the standpipe or the sink the washer drains into, the blockage is in the house plumbing, not the washer. Clear the standpipe or sink drain and test again.
- Decide whether the pump itself has failed — With a clean filter and a clear hose, a pump that doesn't run at all, or runs but moves no water, has usually failed. Drain pumps are the part most often replaced for this problem across every brand.
See the fix for your exact model
The checks above fix most cases. For the causes, codes and parts specific to yours, pick your brand:
Parts that commonly fix it
- drain pump — Shop at RepairClinic or Amazon
- drain hose — Shop at RepairClinic or Amazon
- drain pump filter — Shop at RepairClinic or Amazon
When to call a pro: Call a pro if a new pump still doesn't drain it — that points to the control board or water-level sensor — or if water is leaking from the tub, door seal or hoses.