Washer banging during spin
A washer that bangs, thumps or walks across the floor during spin is almost always an unbalanced load problem — the drum is spinning with the weight clumped on one side. Work through these checks in order; most banging stops at the first two.
First checks — these apply to every brand
- Redistribute the load — Pause the cycle, open the door and spread the laundry evenly around the drum. A single heavy item — a bath mat, a blanket — clumping on one side is the most common cause of banging (this is the unbalanced-load condition behind codes like UE and Ub).
- Fix the load size — Too small is as bad as too big: one heavy item alone will not balance. Add one or two similar items to a tiny load, or take items out of an overloaded drum — about two-thirds full is the target.
- Wash bulky items on the right cycle — Blankets, mats and pillows should be washed one at a time on the bulky/duvet cycle at a medium spin speed, so they don't wad into a single heavy lump.
- Level the machine — Rock the washer corner to corner. If it wobbles, adjust the leveling feet until it sits firm and flat — an unlevel washer vibrates, makes noise and spins poorly even with a balanced load.
- New machine? Check the shipping bolts — If the washer was just installed and has banged since day one, the transit/shipping bolts at the back may still be in. They lock the drum for transport and must be removed before use — check your manual for their location.
- Suspect the suspension — If it bangs even with a small, evenly spread load, the suspension rods (top-load) or shock absorbers/dampers (front-load) that hold the drum centered are likely worn, letting the drum swing into the cabinet.
See the unbalanced-load codes for your brand
The checks above fix most cases. For the causes, codes and parts specific to yours, pick your brand:
Parts that commonly fix it
- suspension rods — Shop at RepairClinic or Amazon
- shock absorbers — Shop at RepairClinic or Amazon
- leveling feet — Shop at RepairClinic or Amazon
When to call a pro: If it still bangs on an empty test spin after leveling, or a suspension rod or spring is visibly broken or detached, the drum support needs repair — a pro job unless you're confident working inside the cabinet.