Robot vacuum won't clean / keeps stopping
A robot that stops mid-clean is usually tangled, jammed with hair, blinded by dirty sensors, or running out of battery — rarely broken. Work through the robot itself first, then the dock.
First checks — these apply to every brand
- Free it from tangles and traps — Cords, curtain hems, rug fringe and low furniture the robot can nose under but not escape are the top reason robots stop. Clear the course, and use a physical barrier or an in-app virtual boundary for repeat trouble spots.
- Clean the main brushes — Hair and thread wound around the main brushes can stall them completely, and most robots stop with a brush error. Pop the brushes out, cut away the hair, clean the end caps, and refit them.
- Check the wheels — Push each wheel in and out — both should spring and turn freely. Hair and debris packed into a side wheel or around the front caster will stop the robot or make it give up and shut down.
- Wipe the cliff sensors — The downward-facing sensors along the front edge stop the robot falling down stairs, and dust on them makes it think it is at a cliff edge. Wipe them with a clean, dry cloth — very dark flooring can also trigger them on some models.
- Tap the bumper free — Debris trapped under the front bumper leaves it permanently 'compressed', and the robot stops because it thinks it is against an obstacle. Briskly tap the bumper a dozen times to shake the debris loose.
- Empty and reseat the dust bin — A full bin, a bin that isn't clicked fully home, or dirty bin contacts all stop a clean. Empty it, wipe the contacts on both the bin and the robot, and refit it until it seats.
- Clean or replace the filter — A clogged filter makes the vacuum motor strain, overheat and shut down mid-clean — the robot may report a vacuum or fan error. Tap the filter clean, and replace it if airflow doesn't come back.
- Check the battery and the dock — Dying a few minutes into a clean, or not charging on the dock, points to the battery or the connection: wipe the charging contacts on robot and dock, confirm the dock has power and the robot is switched on. A battery that no longer holds a charge is a wear item and needs replacing.
See the fix for your exact model
The checks above fix most cases. For the causes, codes and parts specific to yours, pick your brand:
Parts that commonly fix it
- battery — Shop at Amazon
- filter — Shop at Amazon
- main brush — Shop at Amazon
- side brush — Shop at Amazon
- dust bag — Shop at Amazon
When to call a pro: Contact the manufacturer or a repair shop if it still stops with clean brushes and sensors and a battery that holds charge — that points to a drive or vacuum motor or a control-board fault.