Refrigerator won't cool

When a fridge runs but stays warm, the cause is usually something simple: a setting, a door that isn't sealing, or blocked airflow. Work through these checks in order before assuming the cooling system itself has failed.

First checks — these apply to every brand

  1. Make sure cooling is actually switched on — Many fridges have a demo (showroom) mode or a Cooling Off setting that runs the lights and display while disabling cooling entirely. If the display shows OF OF, OFF or Demo, turn the mode off using the button combination in your manual, then give the fridge a few hours to pull down.
  2. Check the temperature settings — Set the refrigerator to about 37°F (3°C) and the freezer to 0°F (-18°C). Settings warmer than that, or controls knocked while loading food, are a common reason for a warm fridge, and temperatures can take up to 24 hours to stabilise after a change.
  3. Check the doors are sealing — Look for food packages, trays or ice propping a door open, then test each gasket with a sheet of paper: it should resist being pulled out all the way around. A worn or torn gasket lets warm air in faster than the fridge can remove it.
  4. Clear the air vents and avoid overpacking — Cold air enters through vents at the back of each compartment, and tall containers or an overpacked freezer can block them. Move large items away from the vents so air can circulate between the freezer and the fresh-food section.
  5. Listen for the fans — Fans circulate the cold air, and they often stop because ice has built up around them after a door was left ajar. If a fan is silent or scraping, unplug the fridge and leave the doors open for a full defrost (at least 12-24 hours), then restart it.
  6. Look for heavy frost on the freezer back wall — Thick frost coating the back wall points to a failed automatic defrost system, which slowly chokes off airflow until nothing cools. A manual defrost buys time, but if the frost and the code come back, the defrost heater, sensor or fuse needs replacing.
  7. Check the condenser fan and clear dust at the back — The condenser fan cools the system at the rear of the fridge; if it is blocked or has failed, temperatures climb. Unplug the fridge, clear anything blocking the rear lower grille, and on models whose manual calls for it, clean dust from the condenser coils.
  8. Confirm the compressor is running — You should hear the compressor humming steadily at the back. Silence, or repeated clicking as it tries and fails to start, points to the compressor, its inverter board or the sealed refrigerant system.

See the fix for your exact model

The checks above fix most cases. For the causes, codes and parts specific to yours, pick your brand:

Parts that commonly fix it

When to call a pro: Call a pro if the compressor won't start, clicks repeatedly, or the fridge still won't cool after a full defrost — compressor, inverter and sealed-system (refrigerant) work is not DIY.