Dryer won't heat

A dryer that tumbles but never warms up has usually lost power to the heater, airflow, or the heater itself. Check the breakers and the vent before the heating parts — they cause more no-heat calls than failed elements do.

First checks — these apply to every brand

  1. Make sure a heated cycle is selected — Run a Timed Dry heated cycle rather than an air-only or fluff setting, and let it run a few minutes before judging. Sensor cycles can also end early with damp clothes if the load is very small, which looks like a heat problem but isn't.
  2. Reset both dryer breakers (electric models) — Electric dryers run on 240 volts from a double breaker: the drum motor needs only one leg, the heater needs both. If one side has tripped, the dryer tumbles with no heat. Switch the double breaker fully off, then on, and retest.
  3. Clean the lint screen and the whole vent run — A clogged screen, duct or outside hood traps heat until the dryer overheats — the root cause behind most blown thermal fuses. Clean the screen, clear the duct, and check outside while it runs: you should feel strong airflow from the vent hood.
  4. On gas models, check the gas supply first — Confirm the gas shutoff valve behind the dryer is fully open and other gas appliances work. If the supply is fine but the burner never ignites, the igniter or gas valve coils have usually failed — and gas ignition work is for a licensed technician. If you smell gas, leave and call the utility.
  5. Suspect the thermal fuse after any overheat — The thermal fuse (or limiter) cuts heat permanently when the dryer overheats, most often because of the blocked vent above. It has to be tested and replaced if open — never bypassed — and the vent must be fixed or the new fuse will blow the same way.
  6. Consider the heating element itself (electric models) — If the breakers, vent and fuse are all good and the air stays stone cold, the element coil has likely burned open. Element testing and replacement means opening the cabinet and working around high-voltage parts, so many people leave it to a technician.

See the fix for your exact model

The checks above fix most cases. For the causes, codes and parts specific to yours, pick your brand:

Parts that commonly fix it

When to call a pro: Call a pro for gas ignition faults, a heating element or fuse you're not comfortable testing, and any burning smell — and fix a blocked vent first, or the new parts will fail the same way.