Porsche SUV Cayenne (955/957, 2003–2010) Driveshaft Vibration and Thumping

What this problem usually means

All first-generation Cayennes (955/957, 2003-2010) wear out the rubber centre support bearing on the propshaft (cardan shaft). The symptom is vibration under acceleration or a thump from the middle of the car, with a rumble at low speed - owners often suspect the transmission or transfer case first, but the sagging centre bearing is the classic cause and the cheaper fix.

Likely causes

  1. Worn rubber centre support bearing on the propshaft
  2. Perished rubber couplings in the driveline → Shop the rubber driveline couplings at Amazon
  3. Propshaft misalignment after the bearing rubber collapses
  4. Transfer case wear, which must be ruled out (different repair)

How to fix it — step by step

  1. Test-drive from a stop and feel for vibration or thumping through the floor under acceleration
  2. Ask whether the shaft or centre bearing has already been replaced
  3. Have the propshaft inspected on a lift - a collapsed bearing is visible as sagging rubber → Shop the propshaft at Amazon
  4. Replace the centre bearing (or shaft assembly) before the vibration damages joints
  5. If vibration persists after the bearing, have the transfer case assessed separately

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Porsche SUV Cayenne (955/957, 2003–2010) problems

See all Porsche Cayenne (955/957, 2003–2010) codes & guides →